Key Responsibilities
The responsibilities of this position include, but are not limited to, the following:
Assemble and test IntelliRupter products based on the documentation including bills of material, blueprints and any change notices provided by the engineering staff.
Complete testing at timing stations and run switch through 4 operations station.
Complete mechanical work including disconnect assemblies.
Experience troubleshooting electrical issues
You will be performing the following tests
Timing Test capacitor voltage 425 DC
Partial Discharge Test AC voltage 50KV
Dielectric test 3 phase AC voltage 60KV-70KV
Calibration test parallel AC voltage 8.7KV-18KV in series 600 amps.
3 phase AC high voltage 8.7KV -18KV with 20 amps – 45 amps.
Low voltage test capacitor voltage 425 DC
What you’ll Need To Succeed
High voltage electrical experience is required to run the required test cells. 5KV / 3phase
Demonstrate the ability to work from complex blueprints, wiring drawings, schematic diagrams, and specifications.
Demonstrate knowledge and experience to troubleshoot mechanical or electrical issues.
Demonstrate experience using and operating machining tools, hand-held tools, wiring equipment, wrenches, torque tools, and other tools.
Must follow all S&C safety standards.
Relevant Work Experience
Two years of experience in electronic assembly and wiring with 5KV
2-year technical degree preferred.
Candidates with electrical or mechanical trade school education may also be considered in lieu of experience
Education
A High School Diploma or GED required
Physical demands
Standing: All tasks are performed in a standing position with intermittent walking.
Lifting: Frequent lifting of items ranging in weight from 5 lbs. to 50 lbs.
Walking: Occasional walking moderate distances (less than 1/8 mile).
Carrying: Frequent carrying of items ranging in weight from 5 lbs. to 25 lbs.
Pushing: Occasional pushing of motorized material handling carts with loaded weights up to 1000 lbs.
Pulling: Occasional pulling of motorized material handling carts with loaded weights up to 1000 lbs.
Bending: Frequent bending and crouching to safely lift parts of various sizes and shapes.
Reaching: Continuous full range of motion from above the shoulders to below the knees.
Handling: Continuous handling of parts ranging in weight from 5 lbs. to 50 lbs.
Other: Respirator certification required.
S&C Electric is committed to equal-opportunity employment. All employees and applicants will be considered without regard to age, color, disability, gender, national origin, race, religion, sexual orientation, gender identity, protected veteran status, or any other classification protected by federal, state, or local law. If you are an individual with a disability and need an accommodation to complete the application, please email us at TAsupport@sandc.com.
No fixed Deadline
#LI-RA1