Position Title
Corrugator Utility
Pay Rate
$23.64
Category/Shift
Hourly Full-Time / 2nd shift 3pm-11pm
Physical Location
Columbus Box Plant
4847 Cargo Drive
Columbus, Georgia 31907
The Job You Will Perform
Use the start up procedures to assure machine set up is performed correctly.
DOUBLE BACKER ROLE
Check to see that all electrical power is on for the glue station & roll stands.
Set damns and put starch into pans.
Peel, load, and record paper of the first cutting list.
Thread paper through the doublebacker splicer and assist operator with running the web onto the bridge.
Cut a tail on the web for threading through the bridge and glue station.
With the aid of the operator, thread the web through the glue station and run the board down to the slitter station.
Strip and load the paper.
Prepare the splicers.
Keep the work area clean.
Help the operator when necessary.
STACKER OPERATOR ROLE
Make sure that both stackers are unlocked and that the electrical power is on for the stackers and the conveyor system.
Cut and collect pull sheets necessary for the orders to be run during the shift. This includes sheet orders and extra pull sheets for the next shift.
Check and clean both stackers
Perform start-up on both stackers
Assist the knife person in running board through the slitter and knife.
BALER OPERATOR ROLE
Complete PIT checklist every shift before driving PIT
Turn on and off (if not running 3 shifts) Balers and Cyclone for each machine center scrap systems
Show the full description
Use the run procedures to assure machine run is performed correctly.
DOUBLE BACKER ROLE
Report to the corrugator 3 to 5 minutes before the start of the shift and talk with the preceding shift’s doublebacker about any problems with the corrugator to see where you are concerning the run at shift change.
Peel and shaft the paper to be run and make sure that the correct paper is on the correct roll stand.
Align the paper, make starch settings at the glue station, and make any other adjustments that are needed to produce a quality product.
Assist the operator with the bookkeeping and running the corrugator as well as doing anything else needed to ensure the continual running of the corrugator.
Make all bridge and tension settings as well as board combination changes at the glue station.
Check the setup and the quality of the board. Notify the operator about warp, loose liner, or paper alignment.
Put good pull sheets under loads and mark each load with the factory order number and the shift, as well as load tags for sheet orders.
Assist the knife person on setups, place tear tape, ludox, Michelman if needed and assist in any way to keep the corrugator running.
Put all good sheets onto WIP lines in an organized manner
Operate the stackers.
Help clean jam ups and keep the dry end running.
STACKER OPERATOR ROLE
Give the knife person breaks.
BALER OPERATOR ROLE
Hog all waste that is brought to the Baler from Corrugator, Converting and Shipping
Enter all Wet End waste into Kiwi Combined Waste Report
Load bale waste railcar
Maintain baler room housekeeping every shift
Empty roll core carts in trailer at Dock 12
Weigh all bales that are produced and log them on the Baler log sheet
Ensure waste is removed from Wet End, Shearer and Dry End throughout the shift
Complete appropriate data entry
The Benefits You Will Enjoy
Paid time off including Vacation and Holidays
Retirement, pension, and 401k Matching Program
Medical & Dental
Education & Development (including Tuition Reimbursement)