Key Responsibilities
Design and develop embedded electronic hardware for industrial products.
Design of Hardware architecture, schematics, circuit calculations, component selection, and documentation design.
Design analog, digital, power supply, microcontroller, sensor-interface, communication, and I/O circuits.
Design hardware for industrial combustion and control applications is preferable,
Flame scanners and flame monitoring systems
Burner management / burner controllers
Fuel delivery and fuel control valves
PLC and industrial control interfaces
Electrical heating and heater-control systems
Combustion safety and monitoring equipment
Interface sensors and actuators such as flame sensors, temperature sensors, pressure sensors, valves, relays, solenoids, heaters, and industrial transmitters.
Design robust industrial interfaces including digital I/O, analog I/O and industrial communication interfaces.
Develop and validate AC/DC and DC/DC power supplies, protection circuits, isolation, signal conditioning, and driver circuits.
Perform component selection, tolerance analysis, power calculations, thermal analysis, and worst-case circuit analysis as required.
Work closely with PCB designers on component placement, routing, grounding, isolation, thermal management, EMI/EMC, and design-for-manufacturing requirements.
Lead prototypes bring-up, debugging, troubleshooting, and root-cause analysis using laboratory equipment.
Develop hardware verification and validation plans and execute engineering tests.
Support EMI/EMC, environmental, reliability, safety, and regulatory testing.
Troubleshoot field and production failures and drive corrective/preventive design improvements.
Support component obsolescence, alternate component qualification, BOM optimization, and product sustaining activities.
Collaborate closely with embedded firmware, mechanical, systems, manufacturing, sourcing, quality, certification, and test engineering teams.
Conduct schematic/design reviews and provide technical guidance to junior hardware engineers
Required Technical Skills
Embedded Hardware
Strong experience in mixed-signal embedded hardware design.
Microcontroller-based system design and peripheral interfacing.
Analog signal conditioning, ADC/DAC interfaces, sensor measurement circuits.
Digital hardware, GPIO, timers and communication interfaces.
Power supply and power-management circuit design.
Relay, solenoid, valve, motor and heater-driving circuits.
Protection against ESD, EFT, surge, reverse polarity, overvoltage and overcurrent.
Isolation techniques suitable for industrial applications.
Industrial Interfaces & Communication
Hands-on experience with interfaces such as UART, SPI, I2C, CAN and RS-485.
Understanding of industrial field interfaces and PLC connectivity.
Experience with 4–20 mA, HART, 0–10 V, digital input/output and industrial sensor interfaces is highly desirable.
Industrial Product Knowledge Preference will be given to candidates with experience in one or more of the following:
Flame detection / Flame scanners
UV / IR flame sensing and monitoring
Burner control systems
Combustion control
Fuel and gas delivery systems
Fuel valves / safety shut-off valves
PLC-based industrial control
Electrical heating and heater controllers
Temperature sensing and control
Industrial safety & monitoring electronics
Global Certification Standard knowledge IEC61508, EN298, IEC60730.
Coordination with Agency TUV, EXIDA, FM, CSA, UL etc.
Testing & Debugging Skills
Candidate should be proficient in using
Digital Oscilloscope
Digital Multimeter
Logic Analyzer
Programmable Power Supply
Electronic Load
Signal / Function Generator
Current probes and other hardware debugging equipment
Strong capability in board bring-up, fault isolation, failure analysis and systematic root-cause analysis is expected.
Safety, Compliance & Reliability
Good understanding of designing reliable electronics for industrial environments.
Working knowledge of EMI/EMC design principles, electrical safety, creepage and clearance, isolation, grounding and protection.
Experience supporting regulatory or product-certification activities is preferred.
Exposure to designing fail-safe or safety-related industrial control products would be an advantage.
Educational Qualification
Bachelor's or Master's degree in Electronics, Electrical, Electronics & Communication, Instrumentation Engineering, or a related engineering discipline.
8–10 years of relevant embedded hardware/product-development experience